#Dd wrt v24 sp2 for linksys e3200 password
Check for the password page and re-login to change the password. Hard reset or 30/30/30 again (If the router supports it, if not, reset to defults in the GUI).Wait for the lights to return to normal usually about 2 minutes.(Unplug the cord, count to 30 and plug it back in.) Failing to wait is how most people brick their routers. You can use the webgui except if you have a belkin router. Check for password page on re-login and change password. Hard reset or 30/30/30 (If the router supports it, if not, reset to defults in the GUI) prior to flashing.Disable wireless on your computer and only have the router connected to the flashing computer by the ethernet cable between the two. (or to whatever subnet the router is on) Disable all firewalls and security. Set your computer to a static IP of 192.168.1.7.Check for recommended builds here first.If stock firmware is on the router follow the flashing instructions. If dd-wrt is already on the router follow these instructions. Set your computer to auto IP and auto DNS.Go in and set your user name and password by carefully typing each of them in.Wait until you can access the dd-wrt webgui at 192.168.1.1.Browse to the dd-wrt.v24_mini_wrt300n.bin you downloaded, and hit upgrade.Go to Administration, Firmware upgrade, in the linksys webgui.Find any settings you might want to keep and copy them down or cut and paste them(e.g.Plug a lan cable from your computer to a LAN port on the router.Set your computer to a static IP address of 192.168.1.7 Subnet mask to 255.255.255.0.Read the peacock announcement found here:.Download DD-WRT v24 Mini from this link:.TomatoUSB K2.6 Support = Yes (NoUSB-Std (4MB flash) only) TomatoUSB K2.4 Support = Yes (NoUSB-Std (4MB flash) only)